Back panel has been added. It will be removed an painted with the same gray as the top brace. The blue "batwing" will be repainted. The blue doesn't do anything for me. The wiring to the servos will be run under the mist cooler and attached to the legs of the panel. Most of the wiring and air lines hanging down on the right side will run to something on the panel. All wiring will be well tied with plastic wire ties and then attached in sufficient places on the panel for security. I don't think it will be necessary, but a piece of black rubber way cover could hang from the top bracket and loosely cover this entire opening. A door of any kind is not necessary.

The round nuts on two of the pulleys are broken. Center pulley is the new 14 tooth. It is complete with bushing. The height is considerably less than the original 1" pulley to its right and also the original 3/4" on its left. Large nut has an i.d. over .9" with a 32 tpi thread. Far right - collet for the 1" pulley. Collet for the 3/4" pulley is inside the pulley. Neither have a key way for the motor shaft.

Previous Page ------------- Next Page ---------- Site Map